Tell us about your project and we will find the best solution to start it ！
Granule packing machine can be divided into large packing and small packing. The granule packing machine is suitable for quantitative packing of rubber granules, plastic granules, fertilizer granules, feed granules, chemical granules, grain granules, building materials granules, metal granules and sealed granules.
The maintenance of the granule packaging machine is essential for long-term use. Let's take a look at the maintenance and precautions of the granule packaging machine.
1. The box part of the machine is equipped with an oil gauge, which should be fully refueled once before driving, and can be added in the middle according to the temperature rise and operation of each bearing.
2. The worm gear box must store oil for a long time. The oil level is such that all the worm gear penetrates into the oil. If it is used frequently, it must be replaced with new oil every three months. There is an oil plug at the bottom of the tank for draining oil.
3. When the machine is refueling, do not let the oil spill out of the cup, let alone flow around the machine and on the ground. Because oil is easy to contaminate materials and affect product quality.
1. Regularly check the parts, once a month, check whether the worm gear, worm, bolts on the lubricating block, bearings and other moving parts are flexible and worn. If defects are found, they should be repaired in time, and should not be used reluctantly.
2. The machine should be used in a dry and clean room, and should not be used in places where the atmosphere contains acids and other gases that are corrosive to the body.
3. After the machine is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the bucket, and then install it properly to prepare for the next use.
4. If the machine is not used for a long time, the whole body of the machine must be wiped clean, the smooth surface of the machine parts should be coated with anti-rust oil and covered with a cloth.
1. Before each startup, check and observe whether there is any abnormality around the machine;
2. During the operation of the machine, it is strictly forbidden for the body, hands and head to approach or touch the moving parts!
3. When the machine is running, it is strictly forbidden to put your hands and tools into the sealing knife seat!
4. When the machine is working normally, it is strictly forbidden to frequently switch the operation buttons, and it is strictly forbidden to frequently change the parameter setting values at will;
5. It is strictly forbidden to run at high speed for a long time;
6. It is forbidden for more than two colleagues to operate various switch buttons and mechanisms of the machine; the power supply should be turned off during maintenance and maintenance; when multiple people debug and repair the machine at the same time, they should pay attention to mutual communication and signal to prevent accidents caused by lack of coordination.
